Sensors & Software CONQUEST 100, User Manual

Page: 74 / 143

Conquest 100 Line Scan
64
Move the Sensor Head forward again and the arrow moves to the right. New data will not be
collected until you reach the point where you stopped and backed up.
Note that the user can only scroll back the last 10m (33 feet), provided their zoom is set
appropriately. To view or back-up the sensor more than 1 screen of data, you need to swipe
from left to right. However, it is not advisable to back up too far when marking out objects, as
it’s difficult to get the sensor back to the same location.
You can obtain depth and position anywhere on the Line Scan by touching the screen for about
two seconds and releasing. A crosshair appears where you touched the screen, along with a
dialog box displaying the position and depth. To get the position and depth information about a
different point on the screen, simply drag the box or crosshair to the desired position (Figure
6-7).
Figure 6-7: Touching the screen for a second at a specific location in back-up mode shows the position and depth of
that point. The crosshair can be dragged to any desired position on the screen
6.6 Flags
Flags can be added to the Line Scan image by pressing the Star (*) key on the Sensor Head or
the Display Unit keypad during data collection (Figure 6-8). These are used to indicate
significant positions on the line, for example, when crossing an object that is visible on the
surface or the change from one surface material to a different one.