14
mode adjustment is performed with
F
parameter input. “Sleep” mode adjustment is shown
in 1.4.5.
F
parameter value is set in seconds (S).
If the parameter is not equal to
zero, signal device will not be switched "sleep” mode
and interrogation period for parameter viewing shall be set as
F+0,5
seconds. Is it recom-
mended to set 5+ seconds for interrogation period; for several signaling devices with deac-
tivated "hibernation mode" in the line it is recommended to set different (+0.5 sec) interro-
gation period.
If the
F
parameter is equal to zero, signal device operates with “sleep” mode and
continuously interrogates the set parameter after being switched out of the “sleep” mode.
Main parameters can be viewed and edited in accordance with 2.4.4.1, 2.4.4.2, as
follows:
-
enter transducer configuration menu;
-
Choose
Sett
menu item.
-
- go to
F
menu sub-item corresponding to required parameter, the current parame-
ter value will be displayed then;
-
- to edit the parameter, enter menu sub-item and type (select) new parameter val-
ue;
-
go to
End
sub-item and exit with saving changes.
Br
menu sub item is used for brightness adjustment.
Brightness value ranges from 0 to 100. The more the
Br
value, the more the bright-
ness. It is recommended to set the middle brightness level value, because the operation
within the highest brightness values shall reduce the lifetime of OLED screen.
2.4.4.2 Configuration table of viewed devices
S.SEE
menu sub item provides adjustment of parameters set for viewing in opera-
tion mode.
The main screen displays: on the left
– record reference number in table, on the
right - device address
A xxx
(picture 2.12).
The table of devices set for viewing can be displayed and edited in accordance with
2.4.4.1, 2.4.4.2, as follows:
-
enter transducer configuration menu;
-
scroll and select
S.SEE
menu item
-
Choose the record for editing and type new device address.
-
To add new record scroll to
Add
menu sub-item and type new device address.
-
go to
End
sub-item and exit with saving changes.
Notes
–
1. Device addresses are sorted automatically by increasing number.
2. If several equal addresses are added, only one of them will be saved.
3. It is acceptable to set up to 128 devices for viewing.
Table of devices set for viewing
Address of device
set for viewing
Ordinal record
number in table
Device address
S.SEE
1. A 1
MS-K-500-3
Address: 90.
Picture 2.12
2.4.4.3 Reaction table adjustment
