ASPEN LED MIRROR CABINET - SE30816C0
INSTALLATION INSTRUCTIONS
A
2 - 2
Installation procedure
1.Open the carton and make sure all the parts listed below are present
Any
Queries
Call
:
0845
0340 780
Waste Electrical & Electronic Equipment Regulations (WEEE) requires that any of our
products showing this mark (left) must not be disposed of with other household or commercial waste.
Sensio
Ltd does not levy any WEEE disposal charges to its customers for affected WEEE related
products.
To prevent possible harm to the environment or human health from uncontrolled waste
disposal,
please separate any such product from other waste types and recycle it responsibly at your
local facilities. Check with your Local Authority, Recycling Center or retailer for recycling advice.
DISTANCE
A
BETWEEN
CENT
RE
OF BRACKETS
2.Mark a desired height of the mirror and draw a horizontal line on the wall which corresponds with the height of the cabinet
hangers. Drill the required holes and insert the wall plugs. Note: Wall plugs supplied are only suitable for solid stone/brick walls.
Then screw the brackets to the all using the screws provided. Please ensure the screws are fully tight.
3.Make the electrical connections, make sure to turn off the electrical supply at the mains. Connection must be made in
accordance with the latest IEE regulations. This cabinet is manufactured to Class I and requires an earth connection.
4.Hang the cabinet on the wall bracket. The claws on the cabinet hangers must be securely located on the wall brackets. Using
a spirit level to adjust the angle of the cabinet by turning the screw A with a cross head screwdriver.When the angle is properly
adjusted, tighten the screw B on both hangers. Then secure the base of the cabinet to the wall with provided screw and
over-cap.
5.Close and secure the internal top electrical cover with the small screws removed earlier. And switch on the electrical supply at
the mains to test the function of the lamp and the shaver socket.
6.Insert the shelf supports in the desired positions starting with the top shelf. On the double door item, one of the doors should
be removed so the glass shelves can be inserted. Please make sure to tighten the plastic screw at the bottom of the shelf
support to prevent the shelves becoming loose. Rubber plugs provided can be used to cover unused shelf holes.
7.If the doors are out of alignment, please first remove the soft-close buffer (from bottom hinges), then adjust the screws A, B
and C on hinges for 3 directional adjustment, see below diagram.
A
B
C
A
3x
1x
7x
2x
12x
1x
1x
8x
7x
1.
2.
3.
4.
A
Choose desired height
from basin (must be a
minimum of 0.6m)
