Sensia 3300 EFM, Installation, Operation & Maintenance Manual

Page: 89 / 101

• To upload a register map via the web interface, log into the Scanner 3300 interface, select
ADMINISTRATION>
GENERAL
from the taskbar and click
Installed Files
at the left of the screen. To erase the map currently installed,
click
Uninstall PMAP File
and click
OK
at the Confirm prompt. Then, click
Browse
under “Install Protocol Map
File,” select the desired configuration (.pmap) file to upload, and click
Open
. From the interface screen, click
Submit
, click
OK
at the Confirm dialog, and wait for the file to upload.
• To upload a register map file via the ScanFlash utility, follow the upload instructions under ScanFlash Upload, page
B-2 .
ScanFlash Upload
Important To download ScanFlash software, visit Sensia’s Measurement website at https://www.sensiaglobal.
com/Measurement/Types/Flow-Computing-and-Automation, choose Scanner Model 3300 Flow Comput-
er , and click the link for the software install.
Important To upload firmware to the Scanner 3300, you must have Administrator-level user access. To upload
configuration files or custom Modbus register maps, you must have Configuration Editor-level or
Administrator-level user access.
1. Download ScanFlash from the Sensia website, as noted above.
2. Open a web browser and enter the IP address of the Scanner 3300 to establish a connection to the device.
3. Download all historical data from the Scanner 3300.
4. Open ScanFlash (shown in
Figure B.1 ) and ensure that the correct model is selected (i.e. 3300).
5. Enter the IP address for the Scanner 3300.
6. Close the browser and clear the browser cache.
7. Select the firmware (BIN), configuration (SCF), Scanner Logic (SLBIN), or Modbus map (PMAP) file to be
uploaded.
Figure B.1 - ScanFlash interface
B-2
Appendix B Scanner 3300 EFM