SensaSound USA LLC V12SW User's Manual
6
Recommend Initial Settings:
From top to bottom, there are four knobs at subwoofer
amplifier board for adjusting volume level, crossover, phase
and power switch. We recommend to do an initial setting first,
then fine-tune to your preference value.
Initial setting suggestion:
LEVEL: 12 o’ clock to 2 o’clock
Crossover: 80-100 Hz
Phase: 0 º
Power: Auto
Frequency Response.........................................................................................20Hz~150Hz
Max Power..................................................................................................................400W
Woofer......................................................................................12"Polypropylene Bass Cone
Type..................................................................................Low-Frequency Reflex Subwoofer
Amplifier Type.............................................................................................Class D Amplifier
Dimensions (W*H*D).........................................................14.2"*15"*14.2"(36cm*38cm*36cm)
Weight........................................................................................................35.2 lbs(16.0 Kg)
Most modern receivers support “On Screen Setup”, you can easily setup your subwoofer by
following the screen setup guidelines.
Enter into receiver’s setup menu and go to “Speaker Setup”. Set the subwoofer value to
“LFE + Main” if your front speakers are “small”; if your front speakers are “large”, then
set up the subwoofer value to “LFE”
When set up the “crossover”, it’s important to match the crossover point between the front
speaker and subwoofer. (e.g. if your front speaker crossover is at 80Hz, your subwoofer should
set at 90Hz for the best result)
In the speaker distance menu, you should measure the distance between your subwoofer and
your mainly listening position, then input the distance value into the menu.
The last step is to set up the volume level. You can set the volume at subwoofer’s amplifier
board at 12 o’clock or 2 o’clock place first, then fine-tune the “level calibration” knob at
receiver for you preference SPL level.
Setting your Subwoofer
Receiver Set Up
V12SW Specification
