SensaSound USA LLC TP900 series user's manual
5
1.If you choose to use bare wire, first separate your wire into two pieces and strip ½”of insulating layer off from the
end of each wire.
2.Twist the exposed copper strands until they are tightly unified.
3.Unscrew the binding posts cap in a counter-clockwise direction.
4.Insert the bare speaker wire into the hole of binding post and tighten it in a turning-clockwise direction. Make sure
that you will not insert the insulation section into the hole as it may interfere the connection.
5.Note that there is a red (+) and a black (-) terminal on the rear of each speaker. Make sure that you connect the
positive (+) terminal of your amplifier or receiver to the red (+) terminal on your speaker, and connect the negative
(-) terminal of your amplifier or receiver to the black (-) terminal on your speaker.
If you prefer to have a flexible location with different speakers, you can choose banana plugs connection
for a convenient connect and disconnect.
1.Most banana plugs has obvious color-coding for red (+) indicates positive terminal and black (-)
indicates negative terminal.
2.Insert the banana plugs respectively into the right end of binding posts on rear of speaker.
3.Make sure that the banana plugs are completely connected with the binding posts.
Connect the positive (+) terminal of your amplifier or receiver to the po) terminal on
Bare Wire
Banana Plugs