1. Using the latch located just above the Sensaphonics logo, open the
(F) battery compartment
and insert a 9V alkaline battery. The battery
fits
only one way: negative terminal up, positive terminal down.
2. Plug one end of the supplied black, 12-inch jumper cable into
the
(E) IEM Input jack
of the 3D bodypack (labeled “Monitor Input”)
on the left side panel. Plug the other end of the jumper cable into your
sound source (e.g., wireless IEM bodypack) where conventional
earphones would plug in. We recommend looping the cable through
the
(H) strain relief
slot beneath the jack prior to plugging in the cable.
A
B
C
E
F
G
D
H
H
A.
Power switch (on/off)
B.
LED indicators
C.
Mode switch
(Perform/Full Ambient)
D.
Microphone outputs
(stereo ambience)
E.
Monitor input jack (stereo)
F.
Battery compartment
G.
3D earphone dual output
H.
Cable strain relief slots (2)
jack
SYSTEM SETUP
J.
Earphone switch (factory
I.
Bass Boost switch
preset)
K.
Limiter switch (on/off)
L.
Ambient Background
volume knob
8
I
J
K
L
The 3D AARO system is designed to work in concert with a
conventional wireless personal monitor system. To set up your
system, you will need a fresh 9V alkaline battery and a working
sound source, such as a wireless in-ear monitor (IEM) system, DJ
mixer, or portable music player. Please refer to the photos indicat-
ing the various controls and features of the 3D-AARO bodypack
mixer. (NOTE: Your system was shipped with a fresh battery
installed and the earphones connected.)
