Sennheiser SKM 5200-II, Instruction Manual

Page: 30 / 37

29
If a problem occurs ...
If a problem occurs ...
If a problem occurs that is not listed in the above table or if the problem
cannot be solved with the proposed solutions, please contact your local
Sennheiser partner for assistance. To find a Sennheiser partner in your
country, search at www.sennheiser.com under “Service & Support”.
Problem Possible cause Possible solution
No operation
indication Batteries are flat or
inserted incorrectly,
battery pack is flat Replace the batteries or
check if they are inserted
correctly or recharge the
battery pack
Transmitter
cannot be
switched off/
Settings cannot
be changed Lock mode is activated Deactivate the lock mode
(see “Deactivating the
autolock function
temporarily” on page 15)
Receiver:
No RF signal Transmitter and receiver
are not on the same
channel Set transmitter and
receiver to the same
channel
Transmitter is out of
range Check the squelch
threshold setting
or reduce the distance
between receiving
antenna and transmitter
Weak signal Antenna signal is
attenuated Do not clasp the antenna
section
Audio signal has
a high level of
background
noise Transmitter’s input
attenuation is adjusted
too high see “Adjusting the
microphone sensitivity –
“ATTEN”” on page 26
Receiver’s output level is
adjusted too low Increase the line output
level
Audio signal is
distorted Transmitter’s input
attenuation is adjusted
too low see “Adjusting the
microphone sensitivity –
“ATTEN”” on page 26
Receiver’s output level is
adjusted too high Reduce the line output
level