15
How to adjust the transmitter frequency
Adjust the desired transmitter frequency with the switch
���
. Each number on the
switch corresponds to a transmitter frequency. You will find the exact frequency
on the type plate in the battery compartment.
왘
Take care that the transmitter frequency and the received frequency
selected at the receiver do correspond.
왘
A small screw driver (breadth approx. 2 mm) or the end of the wire antenna
which is shaped like a small blade is suitable tools for the selection.
How to switch on / how to select sensitivity
The ON/OFF-switch
���
and the selector switch
���
are positioned in a cavity on the
bottom of the housing.
왘
The ON/OFF-switch which is used more frequently is positioned slightly
above the selector switch.
After having switched on the transmitter you must wait approx. 2 seconds as the
transmitter requires this time for adjusting to the chosen frequency. (PLL-rest.).
The AF signal is attenuated if the selector switch for the sensitivity
���
is switched
to „
LOW
“. Close-miking can thereby not result in overmodulation.
왘
Attenuation for SKM 1030: approx. 14 dB
왘
Attenuation for SKM 1032: approx. 20 dB
���
���
���
��� ���