![background image](http://html1.mh-extra.com/html/sennheiser/sdc-8000-ao/sdc-8000-ao_system-manual_1240095076.webp)
Configuring the SDC 8000 system
76
Setting the volume of the consoles’ built-in loudspeakers
The bars on the start display indicate the current volume setting for the
consoles’ built-in loudspeakers.
To set the volume of the consoles’ built-in loudspeakers:
왘
Turn the jog wheel
on the central unit.
If you turn the jog wheel clockwise, the volume of the consoles’ built-in
loudspeakers is increased, if you turn the jog wheel counter-clockwise,
the volume is reduced.
Configuring the conference system
Turning on the central unit for the first time
When turning on the central unit for the first time, the text “
Init
Refused
” is shown on the displays of the conference consoles connected
to the central unit. The conference consoles cannot be detected by the
central unit, since they have not yet been assigned a microphone number.
Your conference system is not yet operational.
왘
First, initialize the conference consoles in order to assign each console
an internal microphone number. You can choose between two
initialization modes: automatic and manual initialization.
Note!
Once you have configured your conference and interpretation system,
the configuration will be retained in memory on turn-off. When turning
on the central unit again, your conference system is immediately
operational.
Automatically initializing all conference consoles
The automatic initialization allows you to initialize all conference consoles
at once. In this case, however, the consoles are assigned microphone
numbers in an arbitrary order.
왘
From the central unit’s operating menu, choose “
Conference
”,
“
Initialize Units
” and “
Automatic Init
” one after the other.
The text “
Please wait
” is shown on the display.
왘
When the text “
Press ENTER to Save initialization
” is shown
on the display, press the ENTER key.
All connected conference consoles are initialized automatically and any
previous configuration is deleted.
>Volume =
P1
P2
P3
P4
P5
P6
Conference
4 Initialize Units
Initialize Units
2 Automatic Init
Automatic Init
Please wait
Automatic Init
Press ENTER to
Save initialization