A
B
C
Connecting the system components
Plug in one end of the connecting cable
to the socket on your sound source (e.g. television).
If necessary, use one of the adapters
,
or
(not included).
Plug in the other end of the connecting cable
to the blue socket
on the transmitter.
Align the antenna
vertically.
Connect the mains unit
to the transmitter
and to the mains.
Place the receiver into the transmitter’s charging compartment
.
Before you use the rechargeable battery
for the first time, charge it until the LED lights up green.
Adjust the volume on your sound source to a sufficient (medium) level.
Switching on and using the stethoset receiver
The receiver automatically switches on when you pull the earbows apart.
First adjust the volume to a low level. This protects your hearing from damage.
Then put the receiver on and adjust the volume to a comfortable level.
If reception is subject to interference, press the
TUNE
button
.
Use the balance control
쐋
to adjust the volume between the left and right ear.
If you cannot hear anything through the receiver, increase the volume on your sound
source.
Switching the stethoset receiver off
The receiver automatically switches off when you take it off.
Charging the stethoset reciever
Place the receiver into the transmitter’s charging compartment
without exerting too much
pressure. With a fully charged battery, the operating time is approx. 9 hours.
For details on the use of the RS 4200, please refer to the enclosed operating instructions.
ON
OFF
Quick instructions
RS 4200
