Sennheiser Freeport, Instructions For Use Manual

Page: 19 / 56

19
Connecting the receiver
왘
Insert the DC connector on the mains cable into the DC socket and
connect it to the mains. The green LED for operation indication
(POWER)
lights up and the receiver is ready for operation.
왘
To deactivate the receiver, remove the mains plug from the mains
outlet.
Aligning the antennas
왘
Set up the antennas and align them upwards in a V-shape.
The LEDs
A and B indicate which diversity section (i.e. which
antenna) is active.
Connecting the amplifier/mixing console
왘
Connect the amplifier/mixing console to the XLR-3M socket or
the ¼” (6.3 mm) jack socket .
왘
Use the GAIN control to adapt the level of the audio output to the
input of the amplifier or mixing console. The adjusted audio output
level is common for both sockets. If the level is adjusted too high,
the audio signal will be distorted. If, on the other hand, the level is
adjusted too low, this will result in an audio signal with high
background noise.
Selecting and changing a channel
You can change the channel on the receiver during running operation.
The receiver then immediately receives on the new channel.
왘
Use a small screwdriver to set the channel selector switch to the
desired channel. You can switch between four different channels
(see “Selecting a channel” on page 24).
freeport.book Seite 19 Mittwoch, 18. Mai 2005 8:35 08