18
Putting the products into operation
1
2 rack mount “ears”
2
1 blanking plate
3
1 jointing plate
4
2 R-SMA extension cables
5
Screw-in R-SMA sockets
6
R-SMA connectors
with washers and nuts
7
2 blanking plugs for closing off the antenna holes in the blanking plate
8
2 recessed head screws
9
6 recessed head screws
Mounting a single receiver into a rack
왘
Unscrew and remove the four screws located on the sides of the receiver
housing.
왘
Secure the rack mount “ears”
1
to the sides of the receiver using the pre-
viously removed recessed head screws (see right-hand diagram).
Make sure that the angled ends of the rack mount “ears” point forward.
왘
Secure the blanking plate
2
to one of the rack mount “ears”
1
using the
two recessed head screws
8
.
Make sure to use the correct side (the one with the round holes) of the
blanking plate
2
to secure it to the rack mount “ear”.
If you want to mount the supplied rod antennas to the front of the rack:
왘
Read the next section.
If you do not want to mount the supplied rod antennas to the front of the rack:
왘
Insert the two blanking plugs
7
into the unused antenna holes.
왘
Slide the receiver into the 19" rack.
왘
Secure the rack mount “ears”
1
and the blanking plate
2
to the rack.
Summary of Contents for evolution D1
Page 1: ...System Manual ...
Page 2: ...2 ...
