48
Turning the system components on and off
Turning the amplifier on/off
The amplifier is fitted with both a mains switch
and an operating switch
. Via the mains switch, the amplifier can be disconnected from the mains
(position “
0
”). The mains switch can always remain set to “
I
”.
씰
When putting the system into operation, turn the amplifer on by setting
the mains switch
to “
I
”. The mains switch can then remain set to “
I
”.
씰
During normal operation, turn the amplifier on or off by using the operating
switch
.
씰
To disconnect the amplifier from the mains, set the mains switch
to “
0
”.
Turning the receiver section on/off
The receiver section is fitted with a separate
ON
/
OFF
switch
which can
always remain set to “
ON
”.
Adjusting the volume of the microphone
Set the MICROPHONE volume control
to “
0
” before you turn the
amplifier on. Adjust the volume of the microphone after turn-on.
Adjusting the volume of connected audio devices
Set the LINE IN volume control
to “
0
” before you turn the amplifier on.
Adjust the volume of the connected audio devices after turn-on.
Note:
With the two volume controls
and
(
, the microphone and LINE IN
signals can be mixed for reproduction at the loudspeaker output.
Turning the transmitter on/off
씰
Slide back the cover plate
.
씰
Press the
ON / OFF
button
to turn the transmitter on. The red LED
lights up.
씰
To turn the transmitter off, press and hold the
ON / OFF
button until
“
OFF
” appears on the display. You can then release the button. The red
LED
goes off.
Muting the transmitter
Use the
MUTE
switch
to noiselessly mute the transmitter’s audio signal
(this switch does
not
turn off the transmitter).
