Using the EK IEM G4
68
Advanced -> Engineer Mode menu item
In the
Engineer Mode
menu item of the
Advanced
submenu, you can con-
figure the menu items and upload profiles.
In Engineer Mode, you can use your EK IEM G4 to read out settings from
other EK receivers and save them as profiles.
You can load these profiles during a live transmission in order to monitor
and, if necessary, adjust an audio signal reproduced by a read-out EK re-
ceiver.
A profile contains the settings of the menu items: “Squelch menu item”,
“Frequency Preset menu item”, “Name menu item”, “Balance menu item”,
“Mode menu item”, “High Boost menu item”, “Advanced -> Tune menu
item”, “Advanced -> Limiter menu item” and “Advanced -> Volume Boost
menu item”.
Profiles List
menu item
•
Create up to 16 profiles and read out the settings of the different EK re-
ceivers.
Load Profiles
menu item
•
Activate/deactivate profile loading
Clear List
menu item
•
Delete all profiles
Profiles List
To read out settings and save them as a profile:
▷
Call up the
Engineer Mode
menu item in the Advanced menu.
▷
Call up the
Profiles List
menu item.
▷
Select an unused profile (a profile without a frequency entry).
▷
Press the
SET
button.
Sync
appears on the display panel of the receiver.
▷
Place the receiver‘s infra-red interface in front of the infra-red interface
of another EK receiver.
The settings of the receiver are assigned to the selected profile.
▷
Repeat this procedure to create profiles of other EK receivers.
You can read out the data of an SR IEM transmitter in the same way.
Please note, however, that these settings will only be up-to-date if
transmitter and receiver have been synchronized before (“Synchronizing
devices”).
When the factory default settings are restored (“Advanced -> Reset menu
item”), all profiles are deleted.
Summary of Contents for EK IEM G4
Page 108: ...107 Block diagram AC 41 ...
