Preparing the antenna module for operation
6
|
ADN-W AM
Connecting the antenna module to the mains power
supply
The antenna module is powered from the ADN CU1 central unit via the
SBC CBL RJ45 system cable.
왘
Connect the hollow jack plug
of the NT 12-50C power supply to
the hollow jack socket
.
왘
Pass the cable through the cable grip
as shown.
왘
Connect the Euro 8 connector of the mains cable to the socket
of
the NT 12-50C power supply.
왘
Connect the mains plug of the mains cable to a wall socket.
If the power supplied via the system cable is not sufficient and
if the antenna module is not listed in the central unit‘s oper-
ating menu under “
System Menu
” > “
Versions
” > “
Hardware
Version Info
” or “
Software Version Info
”:
왘
Use the optional NT 12-50C power supply.
CAUTION
Product damage due to an unsuitable power supply!
If you use an unsuitable power supply, this can cause damage to the
ADN-W AM antenna module.
왘
Only connect the NT 12-50C power supply to the antenna module.
Software Version Info
Main menu
System menu
Versions
No
Hardware Version Info
CU1 SB:
1
ADN PS:
1
AM
1
2
5
EU
UK
US
5
NT 12-50C
2
3
2
2
3
Summary of Contents for ADN-W AM
Page 1: ...ADN W AM Antenna Module Instruction manual...
Page 2: ......
