Using the transmitter
13
Using the transmitter
To establish a transmission link, proceed as follows:
1.
Switch the transmitter on (see below).
2.
Switch the receiver on (see the instruction manual of the receiver).
The transmission link is established.
If you cannot establish a transmission link between transmitter and receiver:
왘
Make sure that transmitter and receiver are set to the same frequency bank and to the
same channel.
왘
If necessary, read the chapter “If a problem occurs ...” on page 21.
Switching the transmitter on/off
To switch the transmitter
on
:
To switch the transmitter to
standby mode
:
왘
If necessary, deactivate the lock mode (see page 16)
To completely switch the transmitter
off
:
왘
Disconnect the transmitter from the mains by unplugging the mains unit from the wall
socket.
The backlighting of the
STANDBY
button
goes off.
Monitoring the audio signal via headphones
You can monitor the audio signal via the headphone output.
It is vital to observe the notes on frequency selection on page 19.
왘
Briefly press the
STANDBY
button
.
The transmitter switches on and the standard display appears.
왘
Keep the
STANDBY
button
pressed until “
OFF
” appears on the display panel.
The display panel then turns off.
When in the operating menu, pressing the
STANDBY
button
will cancel your entry
(ESC function) and return you to the standard display.
The
STANDBY
button
is backlit in red both during operation and in standby mode.
CAUTION!
Danger of hearing damage!
Listening at high volume levels for long periods can lead to permanent hearing defects.
왘
Set the headphone volume control
to the minimum position before putting the
headphones on.
