7
Putting the PXC 350 into
operation
Inserting and replacing the batteries
For powering the NoiseGard Advance active noise
compensation, two AAA size batteries or rechargeable
batteries are required.
왘
Open the battery compartments
on the left and
right earcups.
왘
Remove the flat batteries.
왘
Insert the batteries as shown. Please observe
correct polarity when inserting the batteries.
왘
Close the battery compartments
. The battery
compartment covers lock into place with an audible
click.
Notes:
– The headphones can also be used without
batteries. Switch NoiseGard Advance off before
removing the batteries (see “Switching NoiseGard
Advance on/off” on page 10).
– Always replace the two batteries (left and right)
at the same time.
– Remove the batteries if the headphones will not
be used for extended periods of time.
When the batteries are almost flat, the LED
flashes.
You then have to replace the batteries.
쐋
PXC350_515699_0607_SP6.book Seite 7 Dienstag, 5. Juni 2007 11:47 11
