Senix GTS4QL-M2, Operator'S Manual

Page: 13 / 64

13 WWW.SENIXTOOLS.COM
1. Push in the tabs on the side of the spool retainer and
pull to remove (Fig. 14).
2. Install the spring, washer, and rewound spool,
making sure that the lines are captured in the holding
slots on the new spool.
NOTE: Make sure that the ends of the lines extend
approximately 6 in. (152 mm).
3. Install the new spool so that the line ends align with
the eyelets in the cutting head, and thread the line
ends through the eyelets.
4. Pull the lines extending from the cutting head so that
the strings release from the slots in the spool.
5. Install the spool retainer by pressing the tabs into the
slots and pushing down on the spool until the spool
retainer clicks into place (Fig. 14).
1. Remove the spool from the cutting head.
2. Remove any old line from the spool. Use a clean
cloth to clean the surface of the cutting head.
3. Cut a 15 ft. (4.5 m) length of 0.095 in. (2.4 mm)
diameter trimming line.
4. Bend the line at the midpoint and insert the bend into
the holding slot on the spool (Fig. 15).
5. Wrap the line evenly and firmly around the spool
(Fig. 16).
6. Position the lines in the spool holding slots (Fig. 14).
7. Install the spool in the cutting head. See Replacing
the Spool.
REPLACING THE SPOOL (BUMP HEAD)
REPLACING THE TRIMMING LINE
(BUMP HEAD)
MAINTENANCE
To avoid serious personal injury, always stop the engine
and allow it to cool before cleaning or maintaining the
unit. Never perform cleaning or maintenance while
the unit is running. Disconnect the spark plug wire to
prevent the unit from starting accidentally.
Wear protective clothing and observe all safety
instructions to prevent serious personal injury.
Never use metal-reinforced line, wire, chain or rope.
These can break off and become dangerous projectiles.
Only use the trimming line described in the
Specifications section.
Other types of trimming line may cause the unit to
overheat or fail.
WARNING:
WARNING:
WARNING:
Fig. 14
Washer
Spring
Eyelet
Eyelet
Holding Slots
Tabs
Spool
Retainer
Holding Slot
Split Wall
Fig. 15
Fig. 16