Sengoku OR-77 Replacement Instructions Download Page 1

Page: 1 / 4

Step 6

Unscrew the screw which holds the wind

cover and take off the wind cover.

Step 5

Unscrew 4 wing nuts.

Step 4

Carefully lift off the case.

Step 3

Unscrew 4 screws from the each side of

the case.

Step 2

Remove the wick adjusting knob by pull-

ing straight out. Remove the tank cap.

Step 1

Remove the batteries from the heater.

These Instructions are for the following models: OR-77 and OR-78.

Wick replacement should be performed on a completely cool heater after the tank is empty

and the remainder of the kerosene in the heater has been burned off.

Wick Replacement Instructions for Omni Radiant Ker

osene Heaters

Summary of Contents for OR-77

Page 1: ...Remove the wick adjusting knob by pull ing straight out Remove the tank cap Step 1 Remove the batteries from the heater These Instructions are for the following models OR 77 and OR 78 Wick replacemen...

Page 2: ...ne The black line on the outside of the wick should match the top edge of the holder Then carefully press the wick against the teeth inside the holder to obtain a firm grip Step 10 Remove the wick fro...

Page 3: ...urn Turn the knob clockwise and counter clockwise a few times to make sure that the wick travels up and down smoothly Hold the latch to prevent the safety shut off device from being activated Step 16...

Page 4: ...er chimney position In stall the batteries in the battery case Fill the tank with clean pure 1 K kerosene Wait at least 60 minutes for kerosene to fully saturate the new wick Step 19 Replace the wind...