ENGLISH - 4/8
MI004542-E
Before performing any operation is mandatory to read the full contents of this
manual. The module may only be used by qualified and skilled technicians in the field
of electric installation. Specific documentation is available for download at website:
www.seneca.it/prodotti/z-pass2
Only the Manufacturer is authorized to repair the module or to replace damaged parts.
The product is susceptible to electrostatic discharge, take appropriate countermeasures
during any operation.
No warranty is guaranteed in connection with faults resulting from improper use, from
modifications or repairs carried out by Manufacturer-unauthorized personnel on the
device, or if the content of this user Manual is not followed.
Disposal of electrical & electronic equipment (applicable throughout the EU and other
countries with separate collection programs).
found on this product or on its
The symbol
packaging
,
indicates that this product it must be handed over to an applicable collection point
for the recycling of electrical and electronic
equipments.
PRELIMINARY WARNINGS
COMMUNICATION
PORTS
COM1 RS232/RS485: removable 4 pin connector
.
Max. cable length 3m
COM2 RS485: M1-M2-M3 terminals or IDC10 rear connector.
COM4 RS485: M4-M5-M6 screw terminals.
Max. baud rate: 115 kbps Min. baud rate: 200 bps.
ETH1 and ETH2 Fast Ethernet 10/100 Mbps RJ45 connectors;
USB HOST A type.
Max. connection cable length 100 m.
POWERSUPPLY
Tension
Power absorbed
19 – 40 V
or 19 – 28 V
50 – 60 Hz.
Typical 4W at 24V ; Max. 6W.
DIGITAL INPUTS
Max. number of channels: 4.
Voltage: OFF<4V ON>8V. Max. Current (Vout+): 20mA.
Current absorbed: 3mA at 12V
; 6mA at 24V
.
DIGITAL OUTPUTS
Max. number of channels: 4. Voltage (+Vext): 10
–
24V .Current:
Max. 200mA. Outputs protected against short-circuit and over-temperature.
PROCESSOR
ARM 9 32bit.
MEMORIES
64 MB RAM and 1 GB FLASH
Slot for micro SD card (max. 32 GB Card supported)
Slot for mini SIM card.
MODEM 3G+
GSM / GPRS / EDGE / WCDMA / UMTS / HSDPA / HSUPA / HSPA+
PROTOCOLS
FTP server, SFTP server, HTTP server, ModBUS TCP server,
ModBUS RTU master, ModBUS RTU slave.
CHARACTERISTICS
Embedded Webserver. Firmware upgradable via webserver.
TECHNICAL SPECIFICATIONS
ENGLISH - 3/8
MI004541-E
STANDARDS
EN61000-6-4 Electromagnetic emission, industrial environment.
EN61000-6-2 Electromagnetic immunity, industrial environment.
EN 301 511
.
Harmonized standard for mobile stations
EN 301 489-1 Electromagnetic compatibility for radio equipment.
EN 301 489-7 Specific (EMC) conditions for mobile radioequipment.
EN 60950
Safety of information Technology Equipment.
ISOLATION
ENVIRONMENTAL COND.
Operating Temperature
Humidity
Storage temperature
Protection degree
-20 + 65°C.
–
30% – 90% not condensing.
–
-20 + 85°C.
IP20
MOUNTING
IEC EN60715 DIN Rail.
CONNECTIONS
2
6
,
for up to 2.5 mm
,
removable 3-way terminals 5,08 mm pitch
cable
1 rear IDC10, 1 serial 4 way connector,
1 micro-SD slot, 1 mini-SIM slot, 1 USB connector,
1 SMA connector for GPS antenna, 1 SMA connector for 3G+ antenna
and 2 Ethernet RJ45 connectors.
Easy wiring of power supply and serial communication port through
Seneca
rail bus.
Z-PC-DINAL2-52.5 bus support for IEC EN 60715
TECHNICAL SPECIFICATIONS
5
6
2
3
1
4
14 15
21 22 23 24
19 20
16
ETH1
LAN
ETH2
WAN
ALIMENTAZIONE
RS232
RS485
INGRESSI
E USCITE
DIGITALI
IDC10
1500 V
USB
IDC10
4 POLI
RJ45
RJ45
LED
Status
Description
ETH1 / 2
(Green)
ON
Ethernet 1-2 connection detected
OFF
Ethernet 1-2 connection absent
ETH1 / 2
(Yellow)
Blinking
Ethernet 1-2 data activity
OFF
Ethernet 1-2 no data activity
LED SIGNALLING ON FRONT PANEL
ENGLISH - 2/8
MI004542-E
LED
Status
LED’s meaning
PWR (Green)
ON / OFF
Power supply presence / Device is powered off
RUN (Green) Blinking / OFF Device is ready for use / Device is booting
DIDO1/2
(Green)
ON
Configurable input1 / 2 or output1 / 2 state is HIGH
OFF
Configurable input1 / 2 or output1 / 2 state is LOW
DI / DO
(Green)
ON
DI digital input state is HIGH / DO digital output state is HIGH
OFF
DI digital input state is LOW / DO digital output state is LOW
RCD (Green)
ON / OFF
Remote connection is disabled / Remote connection is enabled
VPN
(Green)
ON / OFF
VPN connection is working properly / VPN connection is disabled
Blinking
VPN connection is not working properly
LAN/WAN
(Green)
ON
Ethernet ports are working in LAN/WAN mode
OFF
Ethernet ports are working in SWITCH mode
SERV
(Green)
ON / OFF
VPN Box “SERVICE” connection is working properly / is disabled
Blinking
VPN Box “SERVICE” connection is not working properly
RX2-4
(Green)
Blinking
RX2 data reception on COM 2 port, RX4 on COM4 port
ON
RX2 check the COM 2 port connection, RX4 check the COM4 port
OFF
RX2 no data reception on COM 2 port, RX4 on COM4 port
TX2-4
(Green)
Blinking
TX2 data transmission on COM 2 port, TX4 on COM4 port
ON
TX2 check the COM 2 port connection, TX4 check the COM4 port
OFF
TX2 no data transmission on COM 2 port, TX4 on COM4 port
3G PWR
(Green)
ON
3G+ modem is powerd ON
STAT
(Yellow)
Slow blinking
0.2s OFF 1.8s ON searching for GSM network
Slow blinking
1.8s OFF 0.2s ON registered on GSM network
Fast blinking
Data transfer in progress
LED SIGNALLING ON FRONT PANEL
Dimensions (W×H×D)
52.5 x 100 x 111 mm
Case / Weight
Material PA6, black color. / 280 g.
1
1
1 mm
52.5 mm
2324
22
2021
19
100 mm
M
A
D
E I
N I
T
A
L
Y
Micro SD Card
Connector
Rear bus
(COM 2 and
Power Supply)
ET005450B
Z-
P
A
S
S
2-R02
Advanced serial
ethernet / 3G gateway
and serial device server
RS232 / RS485
(COM 1)
4 3 2 1
SIM Card
Push-Push
connector
+
DESCRIPTION
+V
out
CONN.
INPUT
OUTPUT
RCD
DI
DIDO1
DIDO2
+V
ext
VPN
DO
GND
12 Vdc, max 20 mA
16
17
18
19
19
20
21
22
23
24
20
Remote Conn. Disable
Free use
Free use
Free use
10 to 24 Vdc
Virtual Private Network
Digital Output
I/O Common
Load
Load
Load
V
ext
Load
+
Z-PASS2
S
SENECA
STAT
GPS
ANT
3G
ANT
PWR
LAN/WAN
RX2
TX2
DIDO1
DI
COM1
USB
1 2 3
4 5 6
RUN
DIDO2
DO
VPN
RCD
SERV
RX4
TX4
13 14 15
3G PWR
W
AN / ETH2
LAN / ETH1
16 17 18
19
22
20
23
21
24
MODULE LAYOUT
ENGLISH - 1/8
MI004541-E
THE ORIGINAL VERSION IS IN ITALIAN LANGUAGE
This document is property of SENECA Srl. Duplication and reproduction are forbidden, if not authorized.
Contents of the present documentation refers to products and technologies described in it.
This informations may be modified or integrated for technical and / or commercial requirements
SENECA s.r.l.
Via Austria, 26 – 35127 – PADOVA – ITALY
Tel. +39.049.8705355 - 8705359 - Fax +39.049.8706287
Manuals and configuration software are available at website: www.seneca.it/products/z-pass2
EN
EN
INSTALLATION MANUAL
Z-PASS2
-IO
VPN Industrial Gateway - Serial Device Server,
with built-in I/O’s - Modem 3G+ / Ethernet Router, GPS
