MI002191-I-E
MI002191-I-E
ENGLISH 5/8
6.0 ELECTRICAL CONNECTIONS
6.1 Power supply
Make sure that the Z107E is power off before
executing any operations.
To power the Z107E is necessary to use a
voltage between 12 .. 28 Vac or between 12 ..
40 Vdc through the terminal 2 and terminal 3.
Alternatively power supply can be provided
through the rear connector IDC10, for Z-PC-
DINAL bus.
6.2 RS 485
5
1
2
3
4
6
Fig. 2
5
3
4
6
Fig. 3
B (-)
GND
A (+)
Ethernet RJ45
6.3 Ethernet
Ethernet communication port with RJ 45 on
the front it’s used to connect by the PC.
Communication velocity up to 100 Mbit / s, with
TCP and UDP protocol.
Porta RS232
6.2 RS 232
The Rs232 serial communication port is
available with DB9-F connector on the side of
Z107E .
It can be used to download the configuration
software in the Z107E when it is in «BOOT»
mode.
The lenght of the cable don’t have exceeded
the 3 m and it must be a pin to pin type. The
cable shall be as described in the following
page.
The RS485 serial communication port is
available on the screw terminals 4 (ground),
5 (A) e 6 (B) as shown in Fig 4.
For the maximum performances it’s
recommended to use a specific shielded
cable.
Alternatively RS485 can be provided through
the rear connector IDC10, for Z-PC-DINAL
bus.
Fig. 5
