User Manual
T201DCH50/100/300/600-MU
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION MAY
BE REPRODUCED WITHOUT PRIOR PERMISSION.
www.seneca.it
Doc. MI00546-EN
Rev.2
Page 5
Two ranges, dip-switch selectable
Damping filter availability to improve stable reading
Modbus RTU protocol by RS485 and USB ports
Modbus Address/Baud Rate/Range/Mode configurable also from dip switch
Suitable for batteries, battery chargers, solar panels, power units and generic dc and ac loads.
Compact size: overall dimensions less than 96,5 x 68 x 26 mm
Baud rate for Modbus RTU: from 1200 baud up to 115200 baud
Start/Stop Input/Output Alarm Values configurable with Easy Setup software
I Max/Min Resettable by Modbus RTU registers
Quick installation on DIN 46277 rail
Refer to the installation manual for more information.
CONFIGURING THE DEVICE
2.
The Device can be configured in two ways:
A basic configuration from dip switches
A full configuration from flash (using Easy Setup Software by the USB port)
WARNING!
Dip switches configuration are active only after a reboot!
WARNING!
The Dip Switch setting will overwrite the Flash setting so, if you need to use the flash configuration
you MUST set ALL dip switches to “OFF”.
