Seneca S6001-RTU, User Manual

Page: 10 / 210

USER MANUAL – Z-TWS4/Z-PASS2-S/S6001-RTU
10
2 Features
Z-TWS4, Z-PASS2-S and S6001-RTU are programmable, communication oriented PLCs.
The Z-TWS4/Z-PASS2-S/S6001-RTU StratON™ PLC is programmable according to the IEC 61131-3 standard, by means
of the StratON development environment.
All three devices provide the following features:

OpenVPN connectivity

full configuration by means of an integrated web site

FW upgrade, that can be performed locally, by means of a USB pen, or remotely, through the web site
Z-PASS2-S and S6001-RTU integrate a 3G HSPA modem.
S6001-RTU is equipped with a rich set of analog and digital inputs/outputs.
Z-PASS2-S, S6001-RTU and Z-TWS4 (when connected to an external modem) can be used as a Router, routing packets
between the WAN (Mobile Network) and the LAN (Ethernet).
All three devices are based on a 32bits ARM9 processor, equipped with the Linux operating system (Linux kernel
2.6.28).
Z-PASS2-S-R01 is a new version of the Z-PASS2-S product, providing the following new features:

the two available Ethernet ports can be configured as two fully separated network interfaces (“LAN” and
“WAN”), whereas in the older versions they could only work as ports of an Ethernet switch; the user can
choose if the two ports shall work in “LAN/WAN” mode or “Switch” mode, by means of a new configuration
parameter (“Ethernet Mode”);

there are 4 more LEDs, providing information about the “Ethernet Mode” and the VPN functionalities.
Z-TWS4-IO is a new version of the Z-TWS4 product, providing the following new features:

one digital input which can be used to disable remote connection to the device

one digital output which goes HIGH when the device is remotely accessed

one digital output which can also be used as a remote command

one configurable digital input/output, which can also be used as a local alarm

a new set of LEDs

COM1 RS232/RS485 mode set by software (configuration parameter), instead of HW DIP switch
Z-PASS2-S-IO is a new version of the Z-PASS2-S product, providing the following new features:

one digital input which can be used to disable remote connection to the device

one digital output which goes HIGH when the device is remotely accessed

one digital input which can also be used as a local alarm

one digital output which can also be used as a remote command

two configurable digital inputs/outputs

a new set of LEDs

COM1 RS232/RS485 mode set by software (configuration parameter), instead of HW DIP switch

a new penta-band 3G+ modem, which also features a GPS module
Z-PASS2-S-IO-4G is a new version of the Z-PASS2-S-IO product, providing a new 4G LTE Cat.1 modem, instead of the
3G+ modem.