4/8
INITIAL POWERING ON OF THE DEVICE
MyBoat is supplied in
“shipping mode”
. This mode prevents any unnecessary discharge of the battery during
transport as well as any accidental switch-ons.
When switched on for the first time, power the device with the power cord supplied
; this allows "shipping
mode" to be exited.
N.B.: During
"shipping mode"
the power button is disabled.
ON/OFF BUTTON AND SCROLL DISPLAY BUTTON
MyBoat is equipped with a PWR button located on the top left side (front panel
view). Pressing this button turns the module on and off. To switch it off, hold the
PWR key down for a few seconds.
MyBoat is also equipped with a SCR button, located on the top right side (front
panel view). Pressing this key displays the parameters.
MICRO USB PORT AND POWER SUPPLY
The device has a micro USB connector on the left side of its enclosure, which can
be used for configuration, firmware updates and to recharge the internal battery.
To recharge the internal battery, use:
- the 12 V power supply (supplied) by connecting the cables to the + and -
terminals (GND).
- a PC via the micro USB port with a standard cable.
Power supply through the USB jack is not suitable for fixed installations, or
configurations where relays and/or digital inputs are used.
PWR
SCR
ANTENNA
ANTENNA
micro
USB
AUTO POWER-OFF
If the display shows
”LOW BAT”,
it means that the internal battery is low, after 60 seconds the device switches off
automatically.
To restore the battery charge to an appropriate value, recharge the device using one of the recommended modes.
INSERTING THE SIM CARD AND SD CARD
INSERTING THE SIM CARD
MyBoat has a slot for mini SIM located in the right side of the enclosure.
To insert the card in its corresponding slot, make sure the metal contacts are
facing right (as seen in the figure).
INSERTING THE SD CARD
MyBoat is equipped with an SD card input that can be used to update the device's
firmware and the information and connection parameters with the world's best
known telephony operators.
Note: DO NOT REMOVE THE CONTENT OF THE SD CARD PROVIDED. THIS
MAY RESULT IN FAILED DATA CONNECTION WITH THE MyBoat SERVICE.
The input for micro SD card is located on the right side of the enclosure.
To insert the SD card in its corresponding slot, make sure the metal contacts are
facing right (as seen in the figure).
SIM
card
SD
card
