ENGLISH - 5/8
MI004930-E
t
PWR
SCR
ANTENNA
ANTENNA
micro
USB
The MyALARM2-
3
is delivered in “
shipping mode
”.
This mode avoid unnecessary discharge of the battery during storage and shipping.
When you switch ON the device, for the first time, please supply power by Usb port or by the included
power supply.
This procedure allows the exit from “
shipping mode
”
.
WARNING:
When the device is turned ON for the first time, it must be supplied, without any interruptions, for at
least 4 hours in order to charge the internal batteries.
3
POWER ON BUTTON AND SCROLL BUTTON
The device has the PWR button, placed in the upper left side (front view).
By pressing this button the module can be switched on.
Hold down the PWR button for a few seconds to turn off the module.
The device has the SCR button, placed in the upper right side (front view).
By pressing of this button you can scroll the display parameters.
3
USB PORT AND POWER SUPPLY
The device has a micro USB socket placed on the left side of case, which can
be used to configure the device, to update the firmware and to recharge the
internal battery.
You can recharge the internal battery with:
- The included 12 V power supply connected to the ter and - (GND).
- A PC through the USB socket.
- An USB power supply (accessory) through the USB socket.
Power supply the device from USB socket is not suitable for fixed installations,
or configurations where relays or digital inputs are used.
3
AUTO POWER-OFF
If the display indicates "
LOW BAT
" then the internal battery is almost empty and the device switches off
automatically after 60 seconds.
To recharge the battery to an appropriate value: power supply the device with one of the above
recommended ways.
SWITCHING THE DEVICE ON FOR THE FIRST TIME
Disposal of electrical & electronic equipment (applicable throughout the EU and other
countries with separate collection programs).
found on this product or on its
The symbol
packaging
,
indicates that this product it must be handed over to an authorised collection point for
the
recycling of electrical and electronic
equipments.
Before performing any operation it is mandatory to read the full contents of this manual.
The module may only be used by qualified and skilled technicians in the field of electric installation
.
www.seneca.it.
Specific documentation is available for download at website:
Only the Manufacturer is authorized to repair the module or to replace damaged parts.
The product is susceptible to electrostatic discharge, take appropriate countermeasures
during any operation.
The warranty is null and void in case of improper use or tampering of the module or devices
supplied by the Manufacturer, necessary for its correct operation and if the instructions in this
manual have not been complied with.
PRELIMINARY WARNINGS
