G4 Headlock Installation Guide
5DOC33150 Rev0
(800) 3-SENECA
(373-6322)
Page 2 of 2
Seneca Dairy Systems, LLC
senecadairysystems.com
Slide Connector in Position.
Tighten handle section first.
Step 5
:
Bolt handle mount to the lockup
control pipe holder at desired location
using 2 provided bolts. Install 2 self-tapping
screws on each side. Handle can be
mounted at any head opening.
Step 6
Move handle to the unlocked
positions (towards individual lock). Rotate
until the Individual Locks are level and slide
control pipe against the lifter until they can
not move further. Tighten the bolts on the
locking collar. This sets the unlocked
position.
Note: Control pipes that are
misaligned may not function as desired.
Step 7:
Slide the connector onto the
control pipe of the first lock and tighten.
Rotate the control pipe of the next section
until the individual locks are level. Slide
control pipe until lifters are completely
pushed to the side and will not move
further. Tighten connector. Proceed to next
section using same method.
: It is critical
for proper function and performance to
have all control pipes positioned correctly.
Locked Position
Slide next section control pipe to locked
position. Ensure individual lock is level
and then tighten the connector
Handle Mount Bolts 2X
Locking Collar
Bolts 8X
Step 7
Self-Tapping
Screws 2X
Unlocked Position
Push Control Pipe to
Unlocked Position.
Rotate until level
Step 5
Step 6