SCP 2100
– User Manual
Page 30 (62)
Configuring IP Transmit
This menu allows the user to configure the IP transmit for the output of MPEG/IP unicast
or multicast, as well as Zixi transport streams. The available options are dependent
upon whether the “Transmit Type” is set for “MPEG/IP” or “Zixi”. The figure below shows
the options available when the transmit type is set to MPEG/IP.
Figure 16: IP Transmit Options - MPEG/IP
Setting
Range
Description
Transmit
Enabled
Disabled
Enable or disable the MPEG/IP transmit
Interface
Network 1 (eth0)
Network 2 (eth1)
Defines which physical port to use for the
MPEG/IP transmission.