- 5 -
Revision 09/2022
Copyright © 2022, Fast ČR, a.s.
that is lower than the current water temperature inside the kettle, two
beeps will be made when the kettle is started. This signals that the set
temperature has already been reached. Water will cool down to the
set temperature and will then be maintained at this temperature. The
keep warm mode ends automatically after 30 minutes.
• To quickly switch the kettle from the stand-by mode to the keep warm
mode, press and hold down button
B2
for 3 seconds. Water will be
maintained at a temperature of 50 °C.
Note:
If you set a temperature using button
B3
and then do not
press button
B2
to start the maintain set temperature mode,
after 15 seconds the kettle will switch to the stand-by mode
and the respective LED indicator
B1
will turn off.
It is not possible to change the set temperature in the keep warm
mode.
The keep warm mode can be stopped at any time by pressing
button
B2
.
Attention:
If the kettle is not located on the base
A6
, the buttons on the
control panel
A7
will not react to being pressed.
Lifting the kettle off the base will cancel all previous
settings. When the kettle is placed back on to the
base
A6
, a short beep will be made and all the LED
indicators
B1
and the LED light
A9
will light up for an
instant and another beep will be made. The kettle
will then again switch to stand-by mode and is again
ready for use.
This kettle is not calibrated for scientific or laboratory
purposes. The actual water temperature may differ by
±5 °C from the set water temperature.
Attention:
Do not turn on the kettle when it is empty. Incorrect use
may negatively affect its lifetime. If you accidentally
turn on the kettle without water inside, after a short
time a sound will be made, the LED light
A9
will turn
off and the kettle will turn off. Wait until the heating
element cools down. This is indicated by a sound and
all the LED indicators
B1
and the LED light
A9
turning
on for an instant. Then the kettle will switch to stand-
by mode and is again ready for use.
5. Pour the boiled or heated water into a prepared container, cup or
mug. Make sure that the kettle remains in a vertical position when
it is carried, particularly if it is filled all the way up to the maximum
mark.
6. If you wish to open the kettle to refill it, be especially careful when
opening the lid
A2
to avoid scalding by the escaping steam.
7.
After you finish using it, disconnect the power cord from the power
socket. Empty the kettle and allow it to cool down.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CLEANING AND MAINTENANCE
1. Removing limescale deposits
• Limescale deposits inside the kettle may negatively affect its lifetime,
so it is important to regularly remove it based on how frequently
the kettle is used. During standard use (3 to 5 times per day), we
recommend water scale deposits be removed:
–
once per month in areas with hard and very hard water;
–
once every two to three months in areas with soft and medium
hard water.
• To remove limescale deposits it is possible to use:
–
8% white vinegar, generally available in stores. Fill the kettle with
1 litre of water and ¼ litre of vinegar. Bring the solution to a boil and
leave it to act in the kettle for 2 hours. Then empty the kettle and
before further use, boil clean water in it four to five times.
–
citric acid. Boil 1.5 l of water in the kettle, into the boiled water,
add 30 g of citric acid and allow the solution to act for about 30
minutes. Then empty the kettle and before further use, boil clean
water in it four to five times.
2. Cleaning the outer surface
• Before cleaning, disconnect the power cord from the power socket.
Empty all the contents from the kettle and allow the kettle to cool
down.
• To clean the external parts of the kettle, use a dry cloth or a cloth
lightly dipped in a weak solution of neutral kitchen detergent. After
applying the detergent, wipe the surface with a lightly damp cloth and
then wipe dry.
• To clean the base
A6
, use only a dry cloth.
• For cleaning, never use steel wool, cleaning products with an abrasive
effect, petrol and other solvents.
Attention:
Do not wash the kettle or its base
A6
under running
water and do not submerge it or its base
A6
in water
or another liquid.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TECHNICAL SPECIFICATIONS
Rated voltage range ................................................................................ 220−240 V
Rated frequency ...........................................................................................50/60 Hz
Rated power input .............................................................................1 850–2 200 W
Nominal capacity ..........................................................................................................2l
We reserve the right to change text and technical specifications.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INSTRUCTIONS AND INFORMATION REGARDING THE DISPOSAL OF
USED PACKAGING MATERIALS
Dispose of used packaging material at a site designated for waste in your
municipality.
DISPOSAL OF USED ELECTRICAL AND ELECTRONIC EQUIPMENT
This symbol on products or original documents means that
used electric or electronic products must not be added to
ordinary municipal waste. For proper disposal, renewal and
recycling, hand over these appliances to determined
collection points. Alternatively, in some European Union
states or other European countries you may return your
appliances to the local retailer when buying an equivalent
new appliance. Correct disposal of this product helps save
valuable natural resources and prevents potential negative effects on the
environment and human health, which could result from improper waste
disposal. Ask your local authorities or collection facility for more details. In
accordance with national regulations penalties may be imposed for the
incorrect disposal of this type of waste.
For business entities in European Union states
If you want to dispose of electric or electronic equipment, ask your retailer
or supplier for the necessary information.
Disposal in other countries outside the European Union.
This symbol is valid in the European Union. If you wish to dispose of this
product, request the necessary information about the correct disposal
method from the local council or from your retailer.
This product meets all the basic requirements of EU
directives related to it.
