Steam iron
SSI 2027BL / SSI 2028YL
EN
EN-9
06/2019
Copyright © 2019, Fast ČR, a.s.
•
Set temperature control dial A
9
based on the fabric type you wish to iron . A lit indicator light A
8
signals that the ironing surface is heating up . As soon as the ironing surface heats up to the set
temperature, the indicator light A
8
will turn off .
Note
:
During first use a weak cracking sound caused by the expanding plastic may be heard . This is an
entirely normal event, which will disappear in a short time .
While ironing the indicator light A
8
will intermittently turn on and off . This indicates that the
set temperature is being maintained .
First iron the laundry that requires the lowest temperature . This will save you time because the
iron heats up faster than it cools down .
If you are ironing at a high temperature and then set a lower temperature, wait until the iron
cools down .
3. Steam
•
Only use the steam function when the temperature control dial A
9
is set to a temperature of
• • to MAX . At a temperature of • • use the regulator A
4
to set a weaker steam output
. At
a temperature of • • • to MAX use the regulator A
4
to set a stronger steam output
.
Note
:
If the set temperature is too low, water may drip from the ironing surface .
The iron continuously emits steam only if you hold it in a horizontal position . Stop the release
of steam by standing the iron upright in a vertical position or by turning the output steam
regulator A
4
to the position marked by symbol
.
FUNCTION OF THE STEAM IMPULSE
•
Press the steam impulse button A
3
to generate a strong flow of steam which can even out even
very crumpled up textiles .
•
Only use the steam impulse function when the temperature control dial A
9
is set to a temperature
of • • • to MAX . If indicator light A
8
turns on, wait until it turns off and only then press the steam
impulse button A
3
. Wait several seconds before pressing the button again .
•
The heat impulse function A
3
can be used when ironing textiles (e .g . curtains, hanging clothes,
etc .) in the vertical position .
SPRAYING FUNCTION
•
The spraying function can be used when the temperature control dial A9is set to any temperature .
Ensure that there is water in the tank A
0
and to dampen the textile press the spray button A
2
.
Note
:
Do not use the spraying function on silk and synthetics .
DRY IRONING
•
If you want to iron without steam, follow the instructions in chapter Steam ironing, point 2 . Setting
the temperature control dial .
•
Set regulator A
4
to the position marked by the symbol
.
