Sencor SPT 232, Instruction Manual

Page: 8 / 14

EN - 8
RADIO OPERATION
AUTOMATIC TUNING
1. Press the “STANDBY / FUNC.” button to select “RADIO” mode.
2. Press and hold the “SKIP + / Tun +” or “SKIP - / Tun -” button over 3 seconds to start automatic
tuning process.
3. When a station is tuned in the tuning process, it will stop automatically and you can listen to your
desired station.
AUTOMATIC MEMORY STATIONS (AMS)
1. Press and hold the „MODE / AMS“ button on unit for about 2-3 seconds to start the automatic
preset process.
2. Display will show the memory sequence number and radio stations will be automatically preset
into the sequence number (Note: Each sequence number means 1 preset station while during
automatic preset process.)
3. Once all the stations were automatic preset, press the “Pre +” or “Pre -“ button to choose preset
stations.
MANUAL TUNING
It is for selecting stations, which cannot be tuned automatically. (manual selection)
To tune a channel manually.
- Skip step 4 in the above “AUTOMATIC TUNING” procedures.
- In step 3, each time the “SKIP + / Tun +” or “SKIP - / Tun -” button is pressed momentarily
(0.5 second or less), the frequency changes by a fi xed step:
FM: 0.1 MHz steps
MANUAL MEMORY PRESET
1. Choose the desired station by following „AUTOMATIC TUNING“ or “MANUAL TUNING” step 1 to
3 procedure.
2. Press „MODE / AMS“ button to enter manual preset station setting.
3. Display will show “P01”
fl ashing.
4. Press “SKIP + / Tun +” or “SKIP - / Tun -” button to choose preset station number.
5. Press „MODE / AMS“ button to con
fi rm chosen preset station number.
6. Once all the stations were preset, press the “PRE - / FOLDER -” or “PRE + / “ button to
choose your desired station.
Radio contens 20 preset stations.
FOR BETTER RECEPTION
- Reorient the antenna for better reception