Sencor ONE 2020, User Manual

Page: 7 / 17

EN 7
EN
Revision 10/2021 Copyright © 2021, Fast ČR, a. s.
Charging
3. Carefully connect the handlebar with the steering pipe. Be careful not to damage the
connecting wire when placing it in the steering pipe. The LED lamp must be facing in
the direction of travel.
4. Screw the handlebar to the steering pipe. Fit the two Allen screws from the front and
the two Allen screws from the opposite side as shown. Tighten the screws. Regularly
check the screws while using the product, if they are not loose.
5. Turn on Scooter One 2020.
4. Charging
Make sure the battery is fully charged before starting to drive. Turn on the Control Panel
and check the battery level.
Charging is carried out using the included charging adapter. First of all, uncover the rubber
cap of the charging connector in Scooter One 2020 and connect the charging adapter.
Then plug the adapter into your wall outlet. After the charging process is complete and
the charging adapter is disconnected, cover the rubber cap of the charging connector
again. Check regularly that the protective cap covers the charging connector whenever
charging is not in progress.