VII Page 1 of 6
IMPORTANT
Please make certain that the person who is to use this equipment carefully reads and understands these
instructions before starting operations.
SAFETY GUIDELINES
Air tool is designed primarily for professional users. User or the user's employer shall assess the specific risks that can be present as a result of
each use. This manual contains information that is important for you to know and understand. This information relates to protect
YOUR SAFETY
and
PREVENT EQUIPMENT PROBLEMS
. To help you recognize this information, we use the symbols shown on the following pages. Please
read the manual and pay attention to these sections.
READ AND FOLLOW ALL INSTRUCTIONS
This tool was designed for certain applications. We strongly recommend
that this tool
SHALL NOT
be modified and/or used for any application other
than it is designed for. If you have any question
relative to its application,
DO NOT
use the tool until you have written to the
distributor and the distributor has advised you.
IMPORTANT SAFETY INSTRUCTIONS
IMPROPER OPERATION OR MAINTENANCE OF THIS PRODUCT COULD RESULT IN SERIOUS INJURY AND PROPERTY DAMAGE. READ AND
UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFORE USING THIS EQUIPMENT. WHEN USING AIR TOOLS, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF PERSONAL INJURY.
APPLICATIONS OF AIR TOOLS
Refer to the Section of
TECHNICAL DATA
for selection of appropriate inserted tool for the specific air tool. Any other use than the intended use of
the specific air tool is forbidden.
Impact drivers
It is intended for tightening/loosening or
installing/uninstalling of threaded fasteners, with
appropriate power socket wrenches or driver bits.
OPERATION INSTRUCTION
General
Before each use:
Always operate, inspect and maintain tool in accordance with all regulations (local, state, federal and country), that may apply to hand held
pneumatic tools.
Drain water from air compressor tank and condensation from air lines. See air compressor’s operation manual.
Disconnect the tool from the air supply before lubricating, installing, removing or adjusting the tool.
Lubricate tool, see “Maintenance“ section in this manual.
Select the required drilling bit depending on the material to be work on.
Connect tool to air hose of recommended size.
Located on the tool housing are model and serial numbers of
your tool, please record these.
Model No.: Serial No.:
CAUTION
WARNING
