13/13
SP-428 Repeater setting & troubleshooting
Setting procedure for SP-428 repeater:
1.Hold the register switch of central unit (CU) around
5
seconds
until the orange color LED which in the left side of CU changing
to fast flashing mode
。
2.Holding the register switch of repeater around
5
seconds until the
LED changing to flash cadence mode( before registered mode,
repeater is in fast flash mode), after
1
minute later repeater and
central unit will change to slower flash mode
。
3.Install this registered repeater to the desired location
。
•
How to check/fix Repeater?
1.When repeater is at the standby mode the LED will in slower flash
mode.
2.If repeater fail to register the CU or never register yet , the LED will
in fast flash state (In base station searching state)
。
3.When a repeater was installed in a desired location, if the RF signal
strength too low for it to link with the base station from the installed
location ,repeater LED will fast flash to show it is in base station
searching state.
4. If the LED of the installed repeater flash slower, But the handset
communication quality not good enough or easy linking off, that
means the repeater was installed in a signal strength margin area,
so please try to move the repeater to the place near the base station
to make sure repeater received a strong enough signal to repeat it
out in high signal quality.
