In this mode, all wireless communications between computers have to be
via the Access Point. (Default setting is
Infrastructure
)
SSID
SSID is an identification code required for communication in a wireless LAN.
You will only be able to connect with a wireless client (802.11 AdHoc) or an
Access Point (Infrastructure) which has the same SSID. If the SSID of a PC
Card is set as
any
, then the PC Card is possible to be connected to all
available Access Point. (Default setting is
IEEE802.11
)
Tx Rate
Select the transmission rate at which the data packets are transmitted by the
client. You can set this to Fully Automatic, 1Mbps, 2Mbps, Auto 1 or 2Mbps,
5.5Mbps, or 11Mbps. (Default setting is
Fully Automatic
)
PS Mode
Power saving management, disabled or enabled. (Default setting is
Disabled
)
Channel
Select the operating radio frequency channel in 802.11 AdHoc mode.
3. Encryption
If you require high security in transmission, you can select 64 or 128-bit
WEP (Wired Equivalent Privacy) key to encrypt data (Default setting is
Disable
) as shown in
Figure 2-8
. WEP encrypts each frame transmitted
from the radio using one of the Keys from this panel. When you use
WEP to communicate with the other wireless clients, all the wireless
devices in this network must have the same encryption key or
passphrase.
15
Summary of Contents for NL-2511CD PLUS EXT2
Page 30: ...operate this equipment 28...
