7
Instructions
▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪
Mounting Instructions
A.flange.mount.is.included.with.the.CXGN.microphone.for.tabletop.or.desktop.
installation..Follow.these.steps.for.mounting.the.flange.to.a.surface.
1.. Place.the.flange.on.the.mounting.surface.in.the.desired.location.for.the.microphone.
2.. Use.a.pencil.to.mark.the.flange.holes.and.the.center.
hole.on.the.mounting.surface..
3.. Remove.the.flange,.and.drill.a.center.hole.
approximately.1
¾
.inch.(44.5.mm).in.diameter.
through.the.mounting.surface.for.the.XLR.
connector.
4.. With.a.small.drill.bit,.drill.three.starter.holes.for.the.
attachment.screws.
5.. Replace.the.flange.over.the.holes,.and.screw.in.the.attachment.screws.until.the.
flange.is.securely.flush.against.the.surface.
