SPH10
12
6.4.1 Multipoint GPS Pairing
If you use GPS only for turn-by-turn voice instructions,
not for Bluetooth stereo music streaming, multipoint
pairing is recommended for the GPS connection.
Multipoint Bluetooth pairing allows the SPH10 to
connect two HFP devices at the same time: mobile
phone and GPS navigation. Follow the steps below to
pair the GPS using the multipoint pairing.
1. Turn on the headset and press the Jog Dial for 5
seconds until the red LED is rapidly flashing and
you hear multiple beeps.
2. Within 2 seconds, tap the Phone Button again, then
the LED turns to blue flashing and the beeps turn
to high tone double beeps. You will hear a voice
prompt saying
“Multipoint pairing”
.
3. Search for Bluetooth devices on the GPS navigation
screen. Select the Sena SPH10 in the list of the
devices detected on the GPS.
4. Enter 0000 for the PIN.
5. The GPS confirms that pairing has completed and
the SPH10 is ready to use. You will hear a voice
prompt from the SPH10 saying
“Your headset is
paired”
.
6. If the pairing process is not completed within three
minutes, the SPH10 will return to stand-by mode.
The pairing diagram for multipoint GPS pairing is
shown in the figure below.
Multipoint GPS Pairing
Smart Phone
SPH10
GPS
HFP
+
A2DP
Mobile Phone
Pairing
Multipoint
Pairing
HFP
6.4.2 GPS Pairing as Mobile Phone
If GPS is not only used for turn-by-turn voice instructions
but also is your preferred Bluetooth stereo music
source, you can pair the GPS to the SPH10 by following
the simple procedures in “6.1 Mobile Phone Pairing”.
When you do this, the SPH10 thinks the GPS is a mobile
phone so you can no longer pair your mobile phone to
the SPH10 directly. However, since some GPS systems
