may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment on
and off, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antennae
• Increase the separation between the equipment and the receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC RF Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. The distance between the antenna of the device and the head surface is at least
15mm and use 15mm or more.
End users must follow the specific operating instructions for satisfying RF exposure compliance.
The antenna used for this transmitter must not transmit simultaneously with any other antenna or
transmitter, except in accordance with FCC multi-transmitter product procedures.
FCC Caution
Any changes or modifications to the equipment not expressly approved by the party responsible
for compliance could void user’s authority to operate the equipment.
Industry Canada Statement
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject
to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
The distance between the antenna of the device and the head surface is at least 15mm and use
15mm or more.
WEEE (Waste Electrical and Electronic Equipment)
The crossed-out wheel bin symbol on the product, literature, or packaging reminds you that all
electrical and electronic products, batteries, and accumulators must be taken to separate
collection at the end of their working life. This requirement applies to the European Union and
other locations where separate collection systems are available. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, please do not dispose of these
products as unsorted municipal waste, but hand it in at an official collection point for recycling.
DOT Certification
This product conforms to the DOT FMVSS 218 (US) helmet safety standards as defined by the
United States Department of Transportation Federal Motor Vehicle Safety Standard. This
certification applies to the United States of America. The approval label can be affixed
permanently to the outside of the helmet (United States, Argentina, Australia and others). Do not
remove or attempt to remove the approval label from the helmet. Do not affix approval labels of
unknown origin to the helmet. These are more than likely counterfeit labels. It is against the law to
affix counterfeit labels to helmets. If you are in any doubt over the origin of the approval label
affixed to your helmet contact Sena directly, and not your dealer.
Product Warranty and Disclaimer
Limited Warranty
