Technical Explanation
SKiiP
®
4 F-Option Board
© by SEMIKRON
2017-08-30 - Rev02
10 / 21
6
Mounting Instruction
6.1
Mounting Instruction for F-Option Board Variants 2 and 3
The mounting process for both Variants 2 and 3 is identic, the description below is shown on example of F-
Option board Variants 2.
The F-Option plastic housing consists of two parts: bottom part (Figure 6.1, left) and top cover (Figure 6.3, left).
1. The bottom part should be placed on the SKiiP
®
4 top cover so that the snap-fits with larger distance (see
green arrows Figure 6.1) match to the slots of SKiiP
®
4 top cover. Afterwards the other side should be
pressed inside applying slight pressure (see red arrows Figure 6.1) till the click is audible.
Figure 6.1: Mounting of bottom part of plastic cover SKiiP4 F-option board
2. The PCB can now be inserted in the bottom part of the F-Option housing (Figure 6.2), where it will be fixed
by pressure parts at the sides (see blue arrows Figure 6.2). One edge of the PCB and housing is cut off
(see red arrow Figure 6.2) to avoid the reversed placing of PCB. It is recommended to insert the PCB into
the housing at the beginning on one side and then to press it inside on the other side applying slight
pressure. Please check the screw holes on PCB match to the holes of bottom part of plastic cover.
