GB
GB
17
Installation
3. Installation
3.1. Installation of the motor into a shaft
1. Crown and coupling adapter need to be determined according to the size of the
shaft.
2. Push the crown adapter over the shaft and position it precisely on the motor
head.
3. Slide the coupling and plugin the coupling locking device.
4. Push the motor into the shaft in a positivelocking way. The motor must not be
subject to any impacts. Crown and coupling adapters must not have any play
inside the shaft.
5. Where required, secure the motor axially, e.g. by screwing the shaft
to the coupling adapter. Do not drill holes into the motor area!
6. Mount the prepared unit with approximately 3 mm axial play into the roller
shutter box (please also see chapter 3.2. Supporting the motors) and fix the cap
against sliding with a short screw.
7. Do not bend the motor cable and place it so that it cannot be damaged. To keep
water from getting into the motor, place the motor line in a bend direction down
wards, so that any water can drip off.