Selve i-R, Operating Instruction, Page: 25 / 60

25
EN
Transmitter programming procedure
Transmitter programming procedure
The operating instructions provided with receivers and other trans-
mitters must be complied with at all times.
1.) Programming the i-R Light Sensor
1.1) With learnt in transmitter or prgramming button on the
receiver
Press the
PROG
button on the receiver or a programmed trans-
mitter for 3 seconds (wait for confirmation: brief upwards and
downwards movement of the motor). The receiver remains in
programming mode for 1 minute. Briefly press (1 sec.) the
PROG
button of the sensor. The sensor has now been programmed.
1.2) Without programming button, if no transmitter is learnt in
yet
Connect the receiver to the electric power supply.
Important:
Please connect only a receiver that has not learned
a transmitter permanently to the power supply system.
Press the PROG button of the i-R Light Sensor for 3 seconds
(wait until the control light flashes
once).
The sensor has now
been programmed.
3 sec.
3 sec.
1 sec.
Sensor Transmitter or
receiver
i-R Light Sensor
➡
3