SELVA MARINE Kingfish 25, Service Manual

Page: 366 / 398

9-76
9
8. Install a new O-ring 5 to the free piston
6 , and then install the free piston 6 into
the cylinder 7 .
9. Place the tilt cylinder end screw
c
at the
bottom of the tilt ram
e
.
10. Install the tilt ram assembly into the cylin-
der.
11. Tighten the tilt cylinder end screw
c
to
the specified torque.
12. Install the PTT motor. See “Installing the
PTT motor” (9-65).
Bleeding the PTT unit
Make sure that the tilt ram is fully extended.
1.
Place the PTT unit in an upright position.
2. Close the manual valve 1 by turning it
counterclockwise.
Recommended PTT fluid: ATF Dexron II
7
6
5
Cylinder-end screw wrench
8
:
90890-06568
Tilt cylinder end screw
c
:
90 N·m (9.0 kgf·m, 66.4 ft·lb)
e
c
c
8
PTT cylinder