Seltron RCD1 Premium, Manual, Page: 11 / 32

| 11 Instructions for use
EN
OPERATION MODE SELECTION
(RCD2 ONLY)
SETTING THE TEMP. FOR FROST PROTECTION
PARTY FUNCTION (RCD2 ONLY)
We can change the setting of the requested room temp. which is considered when the
heating is on. When the heating is off, by pressing the button or recall the display
of the set temp.
If the button or is pressed and held for at least 2 seconds,
the setting value will begin to flash. Now you can change it with buttons and .
By pressing the button we confirm the setting.
By the next press of the button return to the basic display.
For the frost protection to be active, the boiler or the heat generator must be
turned on! Frost protection temp. setting is enabled only when heating is off
and functions Party, Eco and Vacation are not active.
Party function enables to turn on heating according to the requested comfort tempera-
ture at any time. Function can be activated by pressing the button .
Now we can change the requested comfort temperature with buttons and .
Change the setting while the value is flashing. By pressing the or button, we move
to time setting. Use buttons and to set time until when comfort heating should
operate. Change the setting while the value is flashing. By the next press of the button
or return to the basic display.
When the Party function is on, we can check or change settings by pressing button
or .
Party function can be reactivated before expiration of time by pressing again the but-
ton (RCD2 only).
Requested comfort or Party temp.
Time when Party function expires
Party function display