SELKA ELECTRO, Assembly Instructions Manual, Page: 6 / 12

CHARGING THE ELECTRO SMART BATTERY:
The Battery can be charged either via the Control Box or via the Battery
Box. You can also charge the battery removed from the table. To remove the
battery, press the clip on the end of the battery and slide the battery out.
Connect the main cable to the control box and plug cable into mains. When
the charging starts, the battery beeps twice. After approximately five hours,
the battery is fully charged, and the LED light bars turn off.
Disconnect the DC cable from the battery. Connect the DC charging cable to
the battery and plug cable into mains. When the charging starts, the battery
beeps twice. During charging, the LED light bars indicate the actual capacity.
When the charging is complete the LED light bars turn off. Charging will not
start if the capacity is above 75 %.
Turn on the light for a few seconds by pressing the small black button below
the LED light bars. The four LED light bars indicate the actual capacity.
When the capacity is below 25 %, the audio alarm sounds once each time
the battery is activated.
The battery turns off to protect itself when the capacity is approx. 5 %.
Below 5 % capacity, the audio alarm sounds once each time the battery is
activated. No LED light bars can be lit.
Charging via Control Box
Charging via Battery
Capacity
Notes
Read the entire battery user manual here:
Capacity Lit up LED light bars
0 to 5 % None
5 to 25 % LED1
25 to 50 % LED1 and LED2
50 to 75 % LED1, LED2 and LED3
75 to 100 % LED1, LED2, LED3 and LED4
5