ENGLISH - 7
4. Functional description
4-1. Searching the satellite
If the switch is handled in other than the Automatic mode, the unit does not operate
normally.
Consumers should never do this, and if trouble is occurred in Manual mode, guarantee
will not be provided.
Warning
※
Get ready to use
a.
b.
c.
d.
e.
f.
When the controller is turned on, some LEDs light indicate firmware version
(It is made by binary code and for future service purpose)
Once the unit is ready to use, one of satellite LED is lit ON at default satellite
Go to the target satellite using arrows buttons and press SET button to confirm
Before satellite search, HOME LED blinks for antenna status(position) check
(If antenna was not at HOME, antenna has to return to HOME first, LED may blink for a while)
Lock LED blinks during satellite search and becomes solid when the target satellite is found
After use and before travelling, press HOME button for HOME positioning
Default is set Automatic mode;
both dip switches are up.
Customers should use only in
Automatic mode.
Mode selector is for A/S, so it is
not recommended by consumers
to modify it arbitrarily.
4-2. Back to HOME position & Turning off
In some cases, the antenna is automatically stopped and sent to HOME position
A. Automatic
a.
b.
If vehicle drives 25km/h or higher for 20 seconds
If ignition cable is connected and ignition signal is detected
antenna position check (
●
●
)
searching satellite (
●
)/ found (
●
)
firmware ver. (Binary code)
Automatic mode
Manual mode
