USERS | Warranty
4
|
Doc #OI0003 Part #004122 Rev 04 2010
Australian/New Zealand Warranty
Your Selectronic SP PRO product is warranted by the manufacturer for a period of 5 years from date of
purchase to the original purchaser only. The manufacturer will bear the cost of parts and labour to repair any
faults found within the terms and period of this warranty.
Faulty product must be returned to Melbourne Australia for claim under warranty. No allowance is made for
installers labour or travelling time required to disconnect or reinstall faulty parts. Cost of freight to return the
repaired inverter to the customer within Australia or New Zealand only, will be paid by the manufacturer;
method of freight used will be determined by the manufacturer.
Unless otherwise specified to the purchaser the benefits conferred by this voluntary warranty are additional to
all other conditions, warranties, guarantees, rights and remedies expressed or implied by the Trade Practices
Act in your state or territory.
All installation and user conditions as set down in the instruction manual must be strictly adhered to, failure to
do so may void your warranty.
Any faults caused by lightning, water or moisture ingress, faulty installation, using the product in a manner
which it is not intended, vermin infestation, improper voltage, alteration which affects the reliability or
performance of the unit but not attributable to faulty manufacture, failure to act on service warning from the
inverter or faulty generator sets will not be covered under warranty.
In the event of the product being out of service the manufacturer shall bear no responsibility for any
consequential losses or expenses.
The manufacturer will not be held responsible for any misleading or incorrect information conveyed by a
salesperson or installer not directly employed by Selectronic.
A separate Warranty Registration form is included and in part must be completed by the installer.
If your warranty card is returned within 30 days of purchase and installation is signed off by a Selectronic
Accredited SP PRO installer your 5 year warranty will become 7 years.
In the event of service being required during the warranty period, the unit must be returned to Selectronic.
Where the product has been installed by a Selectronic Accredited SP PRO installer, it may be possible to “field
service” the unit on site, this will minimise downtime. Field service is at Selectronic’s discretion.
If you have purchased your SP PRO outside Australia or New Zealand, please see the separate warranty
supplied by the authorised distributor in your country.
Remember, please return your warranty card
.
