M 9 6 5 2 74
FOR AC-VERSION
(MULTI HOOK-UP); Fig. 2, 3
Unit #1
Unit #2
Unit #3
1.
See AC Version Electrical Hook-up for first unit of the
Multi hook-up.
2.
Remove ENCLOSURE COVERS from all
ENCLOSURES.
3.
Remove SOLID BLACK INSERT
(1)
from right side
of ENCLOSURE #1 and replace with gray 2-PIECE
GROMMET
(3)
. Replace solid black inserts on Unit #2
with gray 2-PIECE GROMMET
(3)
.
4.
Take the 10 ft. EXTENSION
(2)
from Unit #2 and
install into right side of Unit #1 and Left side of Unit #2
insealing wire into SPLIT PLUG
(7)
as shown in
Fig. 3a.
Push SPLIT PLUG
(7)
into GROMMET
(8)
.
5.
Insert CONNECTOR from 10 ft. EXTENSION
(2)
into
CIRCUIT BOARD RECEPTOR
(4)
top of Unit #1 as
shown in
Fig. 2.
6.
Insert other end of 10 ft. EXTENSION into LOWER
U GROMMET
(5)
of Unit #2 (approximately 4" from
connector). Fig. 3. Push SPLIT PLUG
(7)
into
GROMMET
(8)
to seal.
7.
Insert connector of 10 ft. EXTENSION into lower
receptor as shown in fig. 3 on CIRCUIT BOARD
(6)
of
Unit #2.
8.
Feed gray sensor wire 9 from Unit #2 through upper
U GROMMET
(10)
of Unit #2 ENCLOSURE 4" from
connector
Fig. 3.
Insert wire into SPLIT PLUG
(7)
.
Push SPLIT PLUG
(7)
into GROMMET
(8)
to seal.
Fig. 3a.
9.
Insert GROMMET
(2)
back into ENCLOSURE.
Fig. 3b
.
10.
Reinstall Circuit Board
(3)
into Enclosure with all
wires under Board.
Fig. 3b.
11.
Connect Unit #2 Red and Black Sensor wires To #2
solenoid valve (Red to +, Black to -).
Fig. 3b.
12.
Repeat Steps 3 through 11 for remaining Units in
Multi Hook-up.
Fig. 2
Fig. 3a
2
5
TWO PIECE
TWO PIECE
GROMMET
GROMMET
TWO PIECE
TWO PIECE
GROMMET
GROMMET
2
1
5
6
1
3
4
4
10
3
9
3
1
1
1
Feed the gray 8 ft. EXTENSION (2) through ROUND
GROMMETS (3) and U GROMMETS (5) as illustrated above.
2
7
2
8
RED
RED
3
BLACK
BLACK
1
Fig. 3b
4"
