Cordless Operating Instructions
WANDCONTROL
TM
1.
To operate your shade, gently pull down on the wand repeatedly until shade reaches desired
position.
2.
If the shade operates in the opposite direction, securely dock the wand into the housing and
twist the handle clockwise or counterclockwise until you hear a click. The click indicates change in
direction.
o Pump the wand gradually.
o Avoid pulling the wand to the end of the cord travel. The abrupt stop may damage the mechanism
and potentially loosen the mounting screws over time.
o When installing into drywall, anchors or plugs
MUST
be used.
o Only twist the wand when docked in the housing unit. Twisting the cords (in an open position) may
damage the mechanism.
TIPS
HOW TO OPERATE
E-TOUCH
TM
NOTE
: when using the PROGRAM button, be sure to press and hold firmly.
FOR ROLLER & HIGH-LITE:
1.
Press UP button to raise shade. Shade will automatically stop when it reaches the upper limit.
2.
Press DOWN button to lower shade. Shade will automatically stop when it reaches the lower limit.
3.
Press STOP to stop your shade while in motion.
FOR SHEER HORIZONTAL:
1.
Tap UP button to move the shade up in small increments. Hold UP button for 2 sec. to automatically
raise shade.
2.
Tap DOWN button to move the shade down in small increments. Hold DOWN button for 2 sec. to
automatically lower shade.
3.
Press STOP to stop your shade while in motion.
4.
Set Middle Stop Position:
a. Move the shade to desired middle stop position.
b. Press and hold the PROGRAM & UP buttons for 3 seconds until motor beeps 4x.
c.
To change middle stop position, repeat steps a & b.
d. Only one middle position is allowed .
5. When stationary, STOP button can be used to move shade to a middle stop position.
6.
Reset Shade Limits
a. Press and hold PROGRAM button for 5 seconds until motor beeps 4x. Limits are now clear.
7.
Setting Upper/Lower Limits
a. Set Upper Limit: Raise shade to desired position. Press PROGRAM button, motor will beep
b. Set Lower Limit: Lower shade to desired position. Press PROGRAM button, motor will beep.
8.
Change Motor Rotation
a. To reverse motor direction, press and hold the PROGRAM & STOP buttons for 2 sec. Shade will
beep 3x.
o E-Touch can be charged with any Micro-USB to USB cable and a charging cube.
o Motor will take 7 hours to fully charge. Ensure you’re using a DC 5V 1A charging cube.
TIPS
Charging Port
Programming
Button
Up
Stop
Down
* To change between Roller and Sheer Horizontal mode, press the
PROGRAM button 3x. The motor will beep 4x in response.
©2022 Select Blinds
How To Operate
