Line up the panel with the frame leg and secure the leg to the wall using #8 x 3" screws.
(If there is a baseboard chisel out that portion of the baseboard at the bottom of the
frame leg so the frame will be flush against the wall). Move the panel on the front track
toward the frame leg where the door opens and closes and follow the same procedure.
Remove the shims if used.
7.Valance Assembly -Insert the valance corners into the
valance and secure them with the screws supplied. Slide the
valance returns over the corner legs and secure them with
screws supplied
8.Valance Installation - Mount the valance to the top frame
rail using 1" x 1" brackets and #6 x 3/4” screws in the pre-
drilled holes.
9. Finishing Touches- If the walls are white or light in color caulk
between the frame legs and where the legs meet the wall . Clean up
excess caulk using a damp rag. Make sure the panels operate smoothly.
Spray silicon spray on the tracks and wheels to insure smooth
operation.
Carrier on Track Method
1. Frame Assemblv & Carrier Insertion - Lay the pieces to the frame on
a smooth surface in front of the opening. Insert the carriers into the tracks on the top
horizontal frame rail. Assemble the frame by attaching the frame legs to the frame
headrail using #8 x 1-1/2” screws into the predrilled holes at the top of the frame legs.
Make sure the back of the frame is facing upward.
2. Headrail Installation -Stand the frame up against the wall and position it around the
door opening. Level the frame. Use shims to raise the legs as necessary to make the
frame level. Attach the frame headrail to the wall using the 2" x 4" brackets and screws
supplied
3. Attach Bottom Panel Guides - Attach the guides to the bottom of the panels using
the’/2" screws supplied.
4. Hanging Panels On Carriers - Hang the shutter panels on the carriers by attaching
the carrier stems into the anchors in the top of the stiles. Adjust the stems of the carriers
until the panels are level, then tighten the lock nuts.
5. Follow steps 6 through 9 above.
