Focusing:
Version 4: December 2008 © 2008 Selecon New Zealand Limited All Rights Reserved
5
The cone of light is adjusted by first loosening the focus knob on the side of the luminaire and then
sliding it towards the front or rear. This moves the lamp and reflector in relation to the lens –
forward increases the beam angle (flood), moving the lamp to the rear narrows the beam angle
(spot).
Take care to move the focus adjustment carefully as the lamp filament is burning white hot and is at
its most vulnerable. Don’t over-tighten the focus knob finger tight pressure is all that’s required.
When focusing, first spot the beam down, position the luminaire and then flood the beam to cover
the area required. The beam can then be shaped using the barndoor accessory (Order Code 20BDMF).
Pan and Tilt Adjustment:
To pan the luminaire, loosen the wingnut and adjust, then retighten. To tilt, loosen the locking clamp handle on the side of
the luminaire, tilt and retighten finger tight.
The tilt lock friction is set by the nylock nut that secures the yoke on the opposite side to the tilt handle. The tilt friction can
be adjusted by loosening or tightening up the nylock nut.
Using the Barndoor Accessory:
The barndoor accessory fits into the front slot of the colour frame holder. It can be rotated to set
the mask angle you require. The barndoor shapes the light beam by masking part of it. It is
effective from a medium beam to flood. In spot focus the barndoor acts only to reduce visible
glare.
Cleaning -
wipe the lens and reflector with a soft rag to remove accumulated dust.
Accessories:
Suspension Hookclamp (Order Code 20HC)
Half Coupler
Mega
Clamp
Lens
Safety
Mesh
(Order
Code
15ACSM)
Four door rotatable Barndoor (Order Code 20BDMF)
FFT Pan Assemly
FFT Tilt Assembly
Colour Frame – each luminaire is supplied with a 125mm (4 7/8 inch) square colour filter holder. Additional colour frames
are available (Order Code 20CFMF)
Safety and Maintenance:
Selecon has manufactured this luminaire in accordance with recognised best practices to recommended international
safety standards. It is your responsibility to maintain this luminaire in good and safe working condition.
Repairs should only be carried out by suitably qualified persons. Do not operate the luminaire with cracked lens, damaged
cable, etc. Consult your Selecon distributor for assistance. Only replace with damaged parts with authorised Selecon
spares.
N.B.
Luminaire cables – your Selecon luminaire is fitted with special heat resistant flexible cable, replace with genuine
Selecon spare part cable kit only – refer to your Selecon distributor. (Replacement cables are supplied complete with
necessary terminal connectors).
Cable conductor colour codes:
ONLY FIT A PLUG IF YOU ARE A SUITABLY
QUALIFIED TECHNICIAN
